Honda Decals (In english)
1 Clean the painted part free of grease and dust. This can be done with water-based silicone remover.
Fix the sticker to the stand with adhesive strips. Do not glue wet!
2 Carefully detach the label from the backing paper on one side.
3 Cut through the backing paper.
4 Using the squeegee supplied, squeegee evenly under pressure in one go.
5 Cut through the fixing tape lengthways. Let the remainder stick to the paint.
This serves as a guide during the subsequent gluing.
6 The cut tape should fit back together after gluing.
7 Now remove the fixings that are no longer needed and turn over the stickers and remove
the other half of the backing paper.
8 Squeegee left side. The tape fasteners should fit back together.
9 Sticker corners if necessary fold over and carefully place the carrier film at an acute angle
pull it off.
10 Check the glued paint part for air bubbles. If you "request" the sticker
If air bubbles become more visible, carefully squeegee them out.
11 Carefully cut the folded decor ends with a sharp cutter knife (not too deep) cut off.
12 In the ideal case, the gluing result should look like this. Before painting should still
cleaned once with water-based silicone remover. The first layer of clear coat
should be thin so that the paint picks up faster and doesn't outgas under the sticker
can.
Please do not use cleaning agents containing lrisem use!
All stickers should then be sealed with a be heated to approx. 70" C in a hot air oven so that
the adhesive can develop its full adhesive strength.Be careful with plastic parts - don't leave them on for too long the same place warm!
Do not stick decors on paint that is too fresh,since the new paint will outgas under the stickers could, Here should have been a few days in between lying
